RIP IPv6 Configuration In Packet Tracer | Networking Academy | #RoutingProtocol |#RIP | #IPv6

IPv6 RIP is an Interior Gateway Protocol (IGP) designed to manage a relatively small network. IPv6 RIP is based on the Bellman-Ford or the distance-vector algorithm. … A IPv6 RIP router broadcasts routing information to its directly connected networks every 30 seconds. IPv6 RIP has limitations and is not suited for every TCP/IP environment. Before using the IPv6 RIP function in OMPROUTE, read RFC 2080 to decide if RIP can be used to manage the IPv6 routing tables of your network.

IPv6 RIP uses the number of hops, or hop count, to determine the best possible route to a host or network. The term hop count is also referred to as the metric. In IPv6 RIP, a hop count of 16 means infinity, or that the destination cannot be reached. This limits the longest path in the network that can be managed by IPv6 RIP to 15 gateways.Next hop IP addresses, whenever applicable, are included in IPv6 RIP updates to eliminate packets being routed through extra hops in the network. IPv6 multicast address FF02::9, reserved for IPv6 RIP packets, is used to reduce unnecessary load on hosts that are not listening for IPv6 RIP messages.

Background Music Credits: Unknown – SergePavkinMusic

#Networking #NetworkAcademy #Academy #CCNA #CCNP #CCIE #Cisco #NetworkeNgineers #Ciscopackettracer #PacketTracer #CLICommands
#Basiccommands #CiscoIOSCommands #DHCP #DHCPConfiguration #Packetrtracer #CiscoRouter #CiscoServer #PacketTracer #RIP #IPv6 .