Van Tech Corner ： OpenWRT – Configure PPPoE

In this video, we are going to setup a PPPoE connection towards the ISP in OpenWRT Luci. The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol which is nowadays used by different Internet Service Providers. Basically, we just neeed to setup our WAN interface in PPPoE protocol, fill in the PAP / CHAP username and password that was provided by the ISP and the interface to WAN zone.

Video timeframe:

00:00 – Introduction and hardware connection
01:00 – Setup WAN interface in PPPoE protocol
02:40 – Verification tests and final words

Check out other OpenWRT tutorials on my channel.

If there is anything not clear or there is any question, feel free to leave it in the comment section and we can discuss.
As always, please like, share and subscribe to the channel to support me. Thank you!

openwrt